0083
TM 1-1740-221-13&P&P
BRAKE RESERVOIRS - (CONTINUED)
1
1
2
3
4
5
WP0074F1
Figure 1. Brake Reservoir (Removal and Installation)
END OF TASK
INSTALLATION
WARNING
The use of Personal Protective Equipment (PPE) is required when using or handling hazardous
materials associated with operating and maintaining equipment (jet fuel, hydraulic luid, brake
luid, ethylene glycol, cleaning solvents, compressed air, and engine/axle oil). Failure to use
PPE when handling these materials could result in injury or death.
NOTE
LH reservoir goes to rear brakes and RH reservoir goes to front brakes.
Installation is the same for both brake reservoirs.
1.
Position brake reservoirs (Figure 1, Item 1).
2.
Install two bolts (Figure 1, Item 2), washers (Figure 1, Item 3) and nuts (Figure 1, Item 4) and tighten.
3.
Connect 2 brake hoses (Figure 1, Item 5).
CAUTION
Do not use automotive brake luid to service the system. Use Hydraulic Fluid (WP 0156 Item
18)
4.
Reill brake reservoirs (Figure 1, Item 1) with hydraulic brake luid to the full mark.
00832
