TM 1-1730-232-13&P
3-16.3 Wheel Assembly Inspection, Model 214-706-104-101 (AVUM).
The Wheel Assembly is group number 03 in the MAC. This procedure is applicable to Ground Handling Wheels
Assembly, Model 214-706-104-101. The numbers in parenthesis refer to figure 3-12. Inspect the wheel assembly as
follows:
Figure 3-12. Wheel Assembly, Model 214-706-104-101
1.
Check for cracked/damaged rims (1 & 2), missing parts (6 thru 9), on wheel assembly. If damaged,
replace wheel assembly using procedures in paragraph 3-16.6 or repair wheel assembly using
procedures in paragraph 3-16.7. Replace any missing parts.
2.
Check for cut, worn, or frayed tires (3). If a tire is defective, replace wheel assembly using procedures
in paragraph 3-16.6 or repair wheel assembly using procedures in paragraph 3-16.7.
3.
Check for grease leaking from wheel assembly bearings packing retainers (4 or 5). If leaking grease,
replace wheel assembly using procedures in paragraph 3-16.6 or repair wheel assembly using
procedures in paragraph 3-16.7.
4.
Check that wheel rotates freely on axle. If wheel rotation is sluggish and axle is good, replace
damaged wheel assembly using procedures in paragraph 3-16.6 or repair wheel assembly using
procedures in paragraph 3-16.7.
WARNING
Never inflate wheel assembly without first checking wheel locknut torques, to insure wheel
locknuts are tightened to specifications. An assembly with missing washers, bolts, nuts or
improperly tightened locknuts could separate under pressure, causing serious injury or death.
5.
Check tire air pressure with tire pressure gauge for 75 psi (51.7 kPa). Inflate if necessary, using
available air source or deflate to proper pressure.
END OF TASK
3-36
