TM 1-1730-232-13&P
Table 2-1. Preventive Maintenance Checks and Services for Ground Handling Wheels Assembly.
(continued)
ITEM
INTERVAL
ITEM TO BE
PROCEDURE
NOT FULLY
NO.
CHECKED OR
MISSION
SERVICED
CAPABLE IF:
3
Monthly
Hydraulic Pump
3.
If level is not OK, install
Fluid level low.
(cont)
(continued)
reservoir cap and notify your
supervisor.
4.
If fluid level is OK, install
Fluid level low
reservoir cap, and complete
inspection.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and
gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes,
and DO NOT use near open flame or excessive heat. The solvent's flash point is 100°F
130°F (38°C 59°C). If you become dizzy while using cleaning solvent, immediately get
fresh air and medical help. If solvent contacts eyes, immediately flush your eyes with
clean water and get medical help.
2-6. CLEANING AGENTS.
Keeping the wheels assemblies clean is an important part of PMCS procedures. Equipment that is covered with surface
dirt, grease, and oil cannot be property inspected. Keep excess lubricants away from exterior parts that do not require
lubrication.
a.
Authorization. Use only those authorized cleaning solvents or agents listed in Appendix D.
b.
Application. Use a wiping rag (item 4, Appendix D) to clean grease, oil, or rust from metal parts. After parts are
cleaned, rinse with dry cleaning solvent (item 6, Appendix D) and dry thoroughly.
c.
Lubrication. Apply light lubricating oil (item 5, Appendix D) to all polished metal surfaces, such as clevis pins,
to prevent rusting.
2-11
