TM 1-1730-232-13&P
4-17.2 Cradle Assembly Repair, Model 1730-EG-100 (AVIM) - Continued
C. ASSEMBLE CRADLE ASSEMBLY
Assemble cradle assembly as follows
1. Install bushing (40) into cradle (1).
NOTE
The axle arms must point in the same direction before installing attaching hardware in
following step.
2. Install axle (2) and axle (3) as follows:
a. Install axle (3) by sliding into bushing (40).
b. Install sleeve spacer (5) by sliding onto axle (3).
c. Install axle (2) by sliding into axle (3)
d. Ensure that axle arms point in the same direction.
e. Align bolt (37) holes and line ream holes, in the side without the spacer (5), to 0.378 to 0.384 Inches, if
necessary.
f. Install washer (35) on bolt (37). Insert bolt (37) through holes in axle (3) and axle (2).
g. Install washer (7) and nut (36) on bolt (37); tighten.
h. Align bolt holes In axle (3), axle (2), and sleeve spacer (5). Line ream holes to 0.316 to 0.322 inches, if
necessary.
i. Install washer (35) on bolt (6). Insert bolt (6) through holes in sleeve spacer (5), axle (3) and axle (2).
j. Install washer (35) and nut (8) on bolt (6); tighten.
NOTE
Trunnion may or may not have a one ram already Installed.
3. Install bushing (41) into cradle (1).
4. Install trunnion (9) by sliding into bushing (41).
NOTE
If no ram is installed in trunnion, perform the following step on both rams.
5. Install a hydraulic ram assembly in accordance with procedure in Chapter 3, Section V, paragraph 3-17.5,
subparagraph B.
6. Install Hydraulic Pump Assembly In accordance with procedure in Chapter 3, Section V, paragraph 3-17.4,
subparagraph B.
7. Install both Wheel Assemblies in accordance with procedure in Chapter 3, Section V, paragraph 3-17.6.
8. Service the Wheel Assemblies, in accordance with procedures in Chapter 3, Section V, paragraph 3-17.6,
subparagraph C.
9. Service the Hydraulic Pump in accordance with procedure In Chapter 3, Section V, paragraph 3-17 4,
subparagraph C.
END OF TASK
4-27
