TM 1-1730-232-13&P
4-15.2 Cradle Assembly Repair, Model 204-050200-5 (AVIM) Continued
C. ASSEMBLE CRADLE ASSEMBLY
Assemble cradle assembly as follows.
1.
Install steel axle sleeve bushing (5) by sliding into aluminum cradle (1)
2.
Install axle (3) as follows:
a.
Slide axle (3) and axle arm (4) over axle sleeve bushing (5).
b.
Align holes and insert bolts (6) through holes in axle arm (4), axle (3), and axle sleeve bushing (5)
c.
Install washers (7), and nuts (8) on bolts (6); tighten.
NOTE
The axle arms must point in the same direction before Installing attaching hardware in following
step.
3.
Install axle (2) as follows:
a.
Slide axle (2) and axle arm (4) over axle sleeve bushing (5).
b.
Ensure that axle arms point in the same direction.
c.
Align holes and insert bolts (6) through holes in axle arm (4), axle (3), and axle sleeve bushing (5).
d.
Install washers (7), and nuts (8) on bolts (6); tighten.
NOTE
Depending on degree of disassembly, the trunnion may or may not have one ram already
installed.
4.
Install trunnion (9) by sliding into cradle (1).
NOTE
If no ram is installed in trunnion, perform the following step on both rams.
5.
Install a hydraulic ram assembly in accordance with procedure in Chapter 3, Section V, paragraph 3-15.5.
6.
Install hydraulic pump assembly in accordance with procedure in Chapter 3, Section V, paragraph 3-15.4.
7.
Install both wheel assemblies in accordance with procedure in Chapter 3, Section V, paragraph 3-15.6.
END OF TASK
4-11
