TM 1-1730-232-13&P
4-15.2 Cradle Assembly Repair, Model 204-050-2005 (AVIM).
The Cradle Assembly is group number 02 in the MAC. The cradle assembly is the mounting point for all other
components or assemblies installed on Ground Handling Wheels Assembly, Model 204-050-200-5. The cradle assembly
need not be disassembled to replace the fixed nose pin, rear support pin, or lubrication fittings. It must be disassembled
to replace an axle, axle arm, sleeve bushing, trunnion, or clevis. Disassembly may require the removal of the wheels,
hydraulic pump, hydraulic hoses, and hydraulic rams. Refer to Figure 4-1 while performing the following repair
procedures.
This task covers: A. Replace B. Disassemble C. Assemble
INITIAL SETUP
Tools
Tool Kit, Aircraft Mechanics General NSN 5180-00-323-4692
Shop Set, AVIM, Hydraulic NSN 4920-00-165-1454
Materials
Grease .......................................................................................P/N MIL-G-10924 (item 7, Appendix D)
Repair Parts
(1) Cradle ............................... 204-050-157-7
(14) Pin, Cotter ........................ MS242665-300
(2) Axle ................................... 205-050-158-11
(15) Fitting ................................ MS15002-1
(3) Axle ................................... 205-050-158-12
(16) Fitting . .............................. MS15001-2
(4) Arm ................................... 204-050-160-1
(17) Pin, Release ..................... 204-050-163-3
(5) Bushing, Sleeve................. 204-050-159-1
(18) Pin, Connection ................ 204-050-154-1
(6) Bolt .................................... 204-050-167-1
(19) Pin, Support ..................... 204-050-164-1
(7) Washer ............................. AN960-616L
(20) Spring ............................... 204-050-133-1
(8) Nut..................................... MS21042L6
(21) Pin..................................... MS171598
(9) Trunnion ........................... 204-050-161-1
(22) Pin, Support, Nose ........... 1730-EG-103
(10) Setscrew ......................... MS51964-94
(23) Bushing, Sleeve ............... 21-010B15-5-51
(11) Clevis, Rod End, LH......... 204-050-170-1
(24) Bushing, Support Pin ........ 204-050-166-3
(12) Pin, Clevis ...................... 204-050-200-13
(33) Setscrew ........................... MS51964-55
(13) Fitting, Lubrication .......... MS15001-4
Personnel Required
MOS 67
GO TO NEXT PAGE
4-7
