0002 00 TM 1-1670-260-12&P __________________________________________________________________________________________ (10) Place the blade sleeve assembly lifting tabs being held in the right hand onto Position 2 of the blade sleeve pole. (11) Place the remaining blue colored lifting tab on the lower edge of the blade sleeve assembly strap onto Position 3 of the blade sleeve pole. (12) Verify that the appropriate blade sleeve assembly bag pocket is still open, and all the other bag pockets are still closed. (13) Pass the snap hook from one end of the adjustable length tie-down sling through the D-ring on the blade sleeve assembly straps marked TOP and secure snap hook to loop position 4 on the adjustable length tie-down. (View C) (14) Connect the snap hook from the fixed length tie-down sling to the D-ring on the blade sleeve assembly straps marked BOTTOM. (15) The blade sleeve assembly is now ready for installation onto the rotor blade. (16) Lift up the blade sleeve assembly with the blade sleeve pole and slide the open blade sleeve assembly bag pocket over the forward pointing rotor blade, while a second person leads the adjustable length tie-down and fixed length tie-down along the rotor blade. CAUTIONTo prevent possible damage to the main rotor system assembly fixed length tie-downs must be secured with approximately 18 inches of slack in the lines. (17) Leaving approximately 18 inches of slack, secure the fixed-length tie-down to the appropriate area of the airframe. (18) Using the unattached end of the adjustable length tie-down already installed repeat steps (1) through (17) for the opposite facing rotor. (19) Carefully orient the middle of the adjustable length tie-down sling near the main rotor mast for easy access during the shackle assembly hook-up in step f. of this Paragraph. f. Rig Shackle Assembly (Figures 1 and 3) NOTE During shackle assembly rigging and subsequent recovery flight all light weight slings and tie-downs attached to the main rotor blades are to be attached to the clevis part of the shackle assembly, while the heavy weight black/white sling is on the shackle assemblies sling spacer (1) Remove quick-release pin, clevis pin and sling spacer from shackle assembly clevis. (5, Figure 1 and Figure 3) (2) Install both sling eyes from the forward red/white safety slings onto the clevis part of the shackle assembly. (3) Install the two sling eyes from the yellow/white sling that is attached to the lifting clevis on the disabled helicopter main rotor onto the clevis part of the shackle assembly. 0002 00-8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business