TM 1-1670-260-12&P
0013 00
__________________________________________________________________________________________
Table 3. Disabled OH-58A/C and Recovery Helicopter Rigging – Key to Figure 1
Figure 1
Item No.
Item Description
1
Lifting Clevis Assembly
2
Yellow/White 153 Inches (12.75 Foot) Light Weight Sling
3
Red/White 208 inches (17.33 ft) Light Weight Sling
4
Red/White 208 inches (17.33 ft) Light Weight Sling
5
Shackle Assembly
6
Black/White 30 Ft Heavy Weight Sling
7
Sling Link Assembly
8
Black/White 30 Ft Heavy Weight Sling with Bridle
9
Blue/White 360 inches (30.0 ft) Light Weight Sling
10
Sling Link Assembly
11
Box Link Assembly
12
Blue/White 360 inches (30.0 ft) Light Weight Sling
13
Box Link Assembly
14
Black/White 120 inches (10 ft) Light Weight Sling
15
OH-58A/C Mast Wedge
16
Black/White 30 Ft Heavy Weight Sling
17
Sling Link Assembly
18
Cargo Hook Thimble
7. Install Main Rotor Rigging (Figures 1, 2 and 3, and Table 3)
NOTE
Figure 1 details the disabled and recovery helicopter
rigging. Reference numbers in the following text that are
outlined in parentheses [i.e., (1), (2), etc.] refer to Figure 1,
View A and Table 3 item numbers. Refer to Figure 1, View
A and Table 3 for configuration guidance.
a. Rotate the main rotor assembly to standard tie-down position. (Figure 1, View A)
b. Install the lifting clevis assembly (1), View A onto the OH-58A/C lifting lug (View B) as follows:
NOTE
The lifting clevis assembly (View B) is attached to the OH-
58A/C lifting lug that is located on the main rotor mast,
above the plane of the main rotor blades. The lifting clevis
assembly will then be attached to slings allowing the OH-
58A/C to be lifted by the recovery helicopter.
(1) Remove the quick-release pin from the locking pin, and then remove the locking pin from the lifting
clevis assembly.
(2) Place the lifting clevis assembly onto the OH-58A/C lifting lug so that the recess in the pivot block
covers the OH-58A/C lifting lug.
(3) Align the holes between the lifting clevis assembly pivot block and the OH-58A/C lifting lug.
(4) Install the locking pin through the pivot block and the lifting lug, and install the quick-release pin into
the locking pin.
c. Pass one sling eye of the yellow/white sling (2), View A, between the lifting clevis assembly’s clevis and pivot
block (View B).
0013 00-5
