TM 1-1270-476-30
E-1/(E-2 blank)
APPENDIX E
TORQUE LIMITS
E-1. GENERAL
An inspector shall be present to verify all torques specified in this manual.
There are two types of applied torques. They are: special torques and standard torques.
Each hardware fastener (except types used in sheet metal work) is assigned an applied torque.
Special torques are given, when needed, in each task. Torques appear in bold type. Torque wrenches
and adapters to be used when a special torque is given are listed under TOOLS in the initial setup.
Special torques usually differ from standard torques.
Standard torques are not in this technical manual. Refer to TM 55-1500-204-25/1 for all standard torque
values.
