TM 1-1270-476-30
4-272
4-31. HOD HARNESS ASSEMBLY REPAIR (cont)
k. Solder pin to inner conductor.
l. Slide insulator (11) over pin contact (10)
until it butts against jerk ring (9) and slide
ferrule (8) forward over jerk ring (9) toward
insulator (11).
m. Hold ferrule (8) in one hand and with the
other hand, push insulator (11) until it is
halfway in the ferrule (8).
n. Have installation inspected.
NOTE
Coaxial connector assembly tool is required
for final assembly of coaxial connector A2P1.
This tool consists of two parts, identified as
part 1 and part 2.
o. Slide coupling nut (7) over ferrule (8) and
screw nut on part 2 (13) of tool.
p. Screw part 1 (14) of tool into part 2 (13)
until insulator is completely seated in
ferrule, and then remove tool.