4-31. HOD HARNESS ASSEMBLY REPAIR (cont)
While removing the connector plate assembly,
the high voltage wire of connector P1 must be
grasped to pull it from its mating connector J1.
c. Remove connector plate assembly (5) by
removing six screws (6) and washers (7).
d. Remove connector J2 (8) by removing four
screws (9), washers (10), and one nut ring
e. Remove faulty contacts from connector J2
(8) (para 2-5).
f. Install replacement contacts in connector
J2 (8) (para 2-5).
g. Install connector J2 (8) with one nut ring
(11), four washers (10), and screws (9).