TM 1-1270-476-30
4-232
4-29. CONTROL PANEL ASSEMBLY 2A1 REPAIR (cont)
j. For either illuminated panel route panel
wires (2) along internal wire bundle and
install lacing and tying tape (1) as required.
k. Cut wires (2) ensuring 4 to 6 inches of
service loop.
CAUTION
When applying heat to hot air shrinkable
splices, take care to avoid damaging other
components.
l. Install hot air shrinkable splice by inserting
lead wire from panel A1, lead wire from
panel A2, and connector wire, then apply
heat with heat gun.
m. Repeat steps j thru l for other splice.
n. Have installation inspected.
o. Fold over excess wire length along internal
wire bundle (A1 side) and install lacing and
tying tape (1) as required.
p. Install HOD assembly (1 above).
END OF TASK