4-8. OIP RELAY BRACKET ASSEMBLY REPAIR (cont)
3. CAPACITOR C1, C2, OR C3 REPLACEMENT
Terminal posts have other wires attached to
them. To replace capacitor C1, C2, or C3 it
may be necessary to tag and unsolder these
a. Tag and unsolder wires from bracket
assembly as follows:
E4 (2) and E6 (3)
E7 (5) and E8 (6)
K1-A1 (8) and K1-B1 (9)
Perform step b only when replacing capacitor
b. Remove epoxy adhesive from capacitor C3
(7) (para 2-6).
c. Remove faulty capacitor.
d. Cut replacement capacitor leads to length
required for installation.
e. Install insulation tubing over each capacitor
f. Solder capacitor leads and other wires to
terminal points as noted in step a. Remove
Perform step g only when installing capacitor
C3; otherwise, go to step h.
g. Secure capacitor C3 (7) in place with epoxy
adhesive (para 2-6).
h. Have installation inspected.
END OF TASK