4-8. OIP RELAY BRACKET ASSEMBLY REPAIR (cont)
2. RESISTOR R2 OR R3 REPLACEMENT
Terminal posts have other wires attached to
them. To replace resistor R2 or R3, it may be
necessary to tag and unsolder these wires.
a. Tag and unsolder component wires from
bracket assembly as follows:
K1-A2 (3) and E3 (4)
E4 (5) and E2 (6)
b. Remove faulty resistor.
c. Cut replacement resistor leads to length
required for installation.
d. Install Insulation tubing over each resistor
e. Solder resistor leads and other wires to
terminal posts as noted in step a. Remove
f. Have installation inspected.
END OF TASK