TM 1-1730-232-13&P
3-17.5 Hydraulic Ram Replacement, Model 1730-EG-100 (AVUM) - Continued.
WARNING
Operator injury or death and equipment damage may occur If the clevis pin mandatory
configuration is not implemented. Mandatory configuration requires one washer (7) under
head of clevis pin (8) and one on other end of clevis pin (8), between clevis and cotter pin (6).
A fracture or stress of clevis pin may occur under hoses helical weighted load.
8.
Connect ram clevis (10) to arm on axle (5) as follows:
a.
Install a washer (7) on head end of clevis pin (8).
b.
Insert clevis pin (8) through holes in clevis (10) and clevis arm of axle (5).
c.
Install washer (7) and cotter pin (6) on clevis pin (8).
d.
Install lubrication fitting (18) In clevis pin (8), unless already Installed.
e.
Repeat steps 8a thru 8d for other axle, if necessary.
9.
Install hose assembly (17) in replacement ram assembly (11), using Teflon Tape (item 8, Appendix D)
and tighten.
10
Install Wheel assembly.
a.
Install wheel assembly (4) on axle hub (5).
b.
Install retainer (3) and castle nut (2).
c. Install cotter pin (1).
NOTE
Ensure freedom of hose movement throughout full travel of rams and axles, without rubbing
on wheel tire. If any interference with movement occurs, reconfigure hose routing to alleviate
the problem.
12. Perform service fill and bleed procedure in C below.
GO TO NEXT PAGE
3-61
