0023 00
TM 1-1670-260-12&P
__________________________________________________________________________________________
WARNING
Failure to arrange sling eyes on the sling link assembly
as shown in Figure 1, View E, will create an unbalanced
load on the sling link assembly and may cause the
assembly to open as tension is applied to the slings.
g. Connect the single eye end of heavy weight black/white sling (6), Figure 1, View A, to the double eye end of
heavy weight black/white sling (7) with bridle loops using sling link (8).
(1) Verify that the arrangement of sling eyes is as shown in View E, with sling (7), View A, bridle loops in
the Position A orientation.
(2) Extend sling (7) out away from the disabled helicopter for easy access during the recovery helicopter
hook-up procedure covered in Paragraph 10 of this WP.
8. Install Tail-Boom Rigging (Figure 1 and Table 3)
a. Fold yellow/white sling (9) in half. (View A)
b. Place the two sling eyes of folded yellow/white sling (9) in-between the heavy weight black/white sling (7) bridle
loops.
WARNING
Failure to arrange sling eyes on the sling link assembly
as shown in Figure 1, View E, will create an unbalanced
load on the sling link assembly and may cause the
assembly to open as tension is applied to the slings.
c. Connect sling link assembly (10) through the bridle loops of sling (7) and through sling eyes of folded
yellow/white sling (9).
(1) Verify that arrangement of sling eyes is as shown in View E, with sling (7) bridle loops in the Position A
orientation.
d. Connect box link assembly (11) to the mid-point fold of sling (9).
(1) Secure sling (9) to box link using box link pin and quick-release pin. (View F)
e. Connect one sling eye of black/white sling (12), View A, to the other end of box link assembly (11) installed on
folded yellow/white sling (9).
(1) Secure sling (12) to box link using box link pin and quick-release pin. (View F)
f.
Connect box link assembly (13), View A, to the other sling eye of sling (12).
(1) Secure sling (12) to box link using box link pin and quick-release pin. (View F)
g. Connect one sling eye of blue/white sling (14), View A, to the other end of box link assembly (13) installed on
black/white sling (12).
(1) Secure sling (14) to box link using box link pin and quick-release pin. (View F)
h. Connect a box link assembly (15), View A, to the other sling eye of sling (14).
(1) Secure sling (14) to box link using box link pin and quick-release pin. (View F)
0023 00-10
