TM 1-1670-260-12&P
0020 00
__________________________________________________________________________________________
Table 3. Disabled UH-1 and Recovery Helicopter Rigging – Key to Figure 1
Figure 1
Item No.
Item Description
1
Lifting Clevis Assembly
2
Yellow/White 153 Inches (12.75 Ft) Light Weight Sling
3
Red/White 208 inches (17.33 Ft) Light Weight Sling
4
Red/White 208 inches (17.33 Ft) Light Weight Sling
5
Shackle Assembly
6
Black/White 30 Ft Heavy Weight Sling with Bridle
7
Sling Link Assembly
8
Black/White 30 Ft Heavy Weight Sling
9
Blue/White 360 inches (30.0 Ft) Light Weight Sling
10
Sling Link Assembly
11
Box Link Assembly
12
Yellow/White 153 Inches (12.75 Ft) Light Weight Sling
13
Box Link Assembly
14
Blue/White 360 inches (30.0 Ft) Light Weight Sling
15
UH-1 Square Wedge Assembly
16
Sling Link Assembly
17
Black/White 30 Ft Heavy Weight Sling
18
Cargo Hook Thimble
b. Install the lifting clevis assembly (1), View A onto the UH-1 lifting lug (View B) as follows:
NOTE
The lifting clevis assembly (View B) is attached to the UH-1
lifting lug that is located on the main rotor mast, above the
plane of the main rotor blades. The lifting clevis assembly
will then be attached to slings allowing the UH-1 to be lifted
by the recovery helicopter.
(1) Remove the quick-release pin from the locking pin, and then remove the locking pin from the lifting
clevis assembly.
(2) Place the lifting clevis assembly onto the UH-1 lifting lug so that the recess in the pivot block covers
the UH-1 lifting lug.
(3) Align the holes between the lifting clevis assembly pivot block and the UH-1 lifting lug.
(4) Install the locking pin through the pivot block and the lifting lug, and install the quick-release pin into
the locking pin.
c. Pass one sling eye of the yellow/white sling (2), View A, between the lifting clevis assembly’s clevis and pivot
block (View B).
(1) Carefully lay the sling eyes for yellow/white sling (2) on the helicopter for easy access during the
shackle assembly hook-up in step f. of the Paragraph.
0020 00-5
