0008 00
TM 1-1670-260-12&P
__________________________________________________________________________________________
(16) Lift up the blade sleeve assembly with the blade sleeve pole and slide the open blade sleeve
assembly bag pocket over the forward pointing rotor blade, while a second person leads the
adjustable length tie-down and fixed length tie-down along the rotor blade.
CAUTION
To prevent possible damage to the main rotor system
assembly fixed length tie-downs must be secured with
approximately 18 inches of slack in the lines.
NOTE
Excellent tie-down points for the fixed length tie-
downs are at the main landing gear trailing arm-
mooring ring and at the wing tip lugs.
(17) Leaving approximately 18 inches of slack, secure fixed-length tie-down to the areas of the airframe
defined by Table 5.
(18) Using the unattached end of the adjustable length tie-down already installed repeat steps (1) through
(17) for the opposite facing rotor.
(19) Carefully orient the middle of the adjustable length tie-down sling near the main rotor mast for easy
access during the shackle assembly hook-up in step f. of this Paragraph.
(20) Repeat steps (1) through (19) above for the other set of rotor blades.
f.
Rig Shackle Assembly (Figures 1 and 3)
NOTE
During shackle assembly rigging and subsequent recovery
flight all light weight slings and tie-downs attached to the
main rotor blades are to be attached to the clevis part of
the shackle assembly, while the heavy weight black-white
sling is on the shackle assemblies sling spacer.
(1) Remove quick-release pin, clevis pin and sling spacer from the clevis of shackle assembly. (5, Figure
1 and Figure 3)
(2) Install one sling eye from green/white sling attached to the 2 o’clock position blade retention assembly
onto the clevis part of the shackle assembly.
(3) Place both sling eyes from green/white sling attached to the 8 o’clock position blade retention
assembly onto the clevis part of the shackle assembly.
(4) Place the remaining green/white sling eye the from the 2 o’clock position blade retention sling onto the
clevis part of the shackle assembly.
(5) Install one sling eye from green/white sling at the 10 o’clock position blade retention assembly onto
the clevis part of the shackle assembly.
(6) Place both sling eyes from green/white sling attached to the 4 o’clock position blade retention
assembly onto the clevis part of the shackle assembly.
0008 00-8
