TM 55-1860-320-23 & P
3-38. LIMIT SWITCH DRIVE ASSY - REPAIR (cont)
3-38
i. Connect electrical wiring to switch (23) and install switch into housing (20). Secure using washer (26), nut (25)
and cap (24).
j. Install shims (18) into retainer (8).
k. Lubricate bearing (17) with grease and install onto gear (16). Lubricate bearing (14) with grease and install into
cluster gear (15).
1. Install shaft (3) into bearing (14). Lubricate bearings (13) with grease and install onto shaft.
m. Lightly lubricate cluster gear (15) and gear (16) with grease. Fit gears together on shaft (3).
n. Install shaft (3) and assembled gears into retainer (8). Adjust number of shims (18) installed in step j. to achieve
a shaft end play of 0.004-0.008 in. (0.010-0.020 cm).
o. Install cover (19), after completion of adjustment procedures, using secure using screws (21) and washers (22).
GO TO NEXT PAGE
3-133