TM 55-1680-320-23 & P
3-36. WINCH ASSEMBLY - REPAIR (cont)
3-36
d
e.
f.
g.
h.
Using a 10-32 screw, install level wind shoe
(55) and retainer (54).
Install shims (53), as required, to obtain an
end play of 0.004-0.008 in. (0.010-0.020 cm)
between shoe (55) and retainer (54). Install
retaining ring (52) into drum assembly. Align
matched curved surfaces.
Position drum assembly (51) near flush with
drum cover assembly (50) by rotating drum
in relation to cover.
Lower assembled drum (51) and cover (50)
into winch housing (28). Ensure proper align-
ment of drum shaft and drum drive gear splines.
Align cover (50) to housing (28) to enable
installation of limit switch drive assembly ( 10).
Install screws (45, 46), washers (47, 48) and
nuts (49), Torque screws to 12-15 in-lbs.
GO TO NEXT PAGE
Change 2
3-121