0087
TM 1-1740-221-13&P&P
PARK POSITION CALIPER - (CONTINUED)
Turn ignition switch on, release the hand brake and place the gear shifter in park and check
that the park position motor engages the disk. Place the gear shifter in any gear and observe
the park position motor disengages the brakes. Turn ignition switch off.
1.
Chock front wheels.
2.
3.
4.
Remove clevis mount bolt and nut (Figure 1, Item 1).
5.
Remove caliper arm nut (Figure 1, Item 6).
6.
Remove caliper actuator arm (Figure 1, Item 7) and bottom clevis (Figure 1, Item 9) as an assembly.
7.
Loosen caliper adjustment lock bolt (Figure 1, Item 2).
8.
Loosen caliper brake pad adjustment insert (Figure 1, Item 5).
9.
Remove 2 caliper mount bolts and nuts (Figure 1, Item 3).
10.
Remove caliper assembly (Figure 1, Item 4).
END OF TASK
INSTALLATION
NOTE
Loosen brake caliper pad adjustment lock bolt and open the pads prior to installation of the
caliper assembly.
1.
Position caliper assembly (Figure 1, Item 4).
2.
Install 2 caliper mount bolts and nuts (Figure 1, Item 3).
3.
Tighten caliper brake pad adjustment insert (Figure 1, Item 5) until the brake pads contact the disc then
back out the insert 1/8 of a turn.
4.
Tighten caliper insert adjustment lock bolt (Figure 1, Item 2).
NOTE
Install caliper actuator arm on the caliper spline shaft at the 9:00 o-clock position.
5.
Install caliper actuator arm (Figure 1, Item 7) and bottom clevis (Figure 1, Item 9) as an assembly.
6.
Install clevis mount bolt and nut (Figure 1, Item 1).
7.
Install caliper arm lock nut (Figure 1, Item 6).
8.
NOTE
Turn ignition switch on, release the hand brake and place the gear shifter in park and check
that the park position motor engages the disk. Place the gear shifter in any gear and observe
the park position motor disengages the brakes. Turn ignition switch off.
9. Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE
00872