FAN BELT - (CONTINUED)
Place belt over all pulleys, using care not to twist the belt.
Use a pry bar and pull the alternator (pressure on the alternator frame) until belt is tight.
Hold pressure and tighten alternator adjustment bolt (Figure 1, Item 1).
Apply thumb pressure on the center of the belt between the crankshaft and alternator. Acceptable delection is
between 0.39 to 0.47 inches (10 to 12 mm).
Tighten bottom alternator mount bolt (Figure 1, Item 2).
Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE