TM 1-1730-215-13&P
0014 00
INSTALLATION CONTINUED
3.
Position inside scissors assembly (Figure 2, Item 12) into outside scissors assembly (Figure 2, Item 19) and
install scissors pin (Figure 2, Item 7) using washers (Figure 2, Item 1) and pins (Figure 2, Item 5).
4.
Install washers Figure 2, Item 16, rollers (Figure 2, Item 15), hinge pins (Figure 2, Item 14) and roll pins
(Figure 2, Item 13) attaching lower end of inside scissors (Figure 2, Item 12) to main frame.
5.
Position floor plate above scissors assembly.
6.
Install pin shields (Figure 2, Item 4), rollers (Figure 2, Item 3), hinge pins (Figure 2, Item 1) and roll pins on
both sides of upper end of outside scissors assembly.
7.
Install hinge pins (Figure 2, Item 2 and 8) and roll pins (Figure 2, Item 1 and 9) on both sides of upper end of
inside scissors assembly.
8.
Install cylinder assembly by positioning lower mount on cylinder (Figure 1, Item 5) to mounting bracket on
outside scissors (Figure 1, Item 8).
9.
Install bolt through lower mount. Do not tighten bolt at this time.
10. Swing cylinder (Figure 1, Item 5) into position and attach cylinder ram (upper end) to inside scissors (Figure
1, Item 7).
11. Install bolt in upper end and tighten both bolts as required.
12. Connect one end of hydraulic hose (Figure 1, Item 3) to cylinder assembly (Figure 1, Item 5).
13. Attach hose to scissors assembly (Figure 1, Item 7 and 8) using five clamps originally removed.
14. Connect hose to hydraulic pump fitting.
15. Install upper ladder (Figure 1, Item 4) and guard rails (Figure 1, Item 1 and 2) in (WP 0012 00).
INSPECTION OF INSTALLED ITEMS
1.
Thoroughly clean all parts using Cleaning Compound, Solvent and dry with a clean lint-free cloth.
2.
Inspect scissors frame (Figure 2, Item 7 and 8) for cracks or other damage. If damaged, replace.
3.
Inspect and replace any rollers (Figure 2, Item 3) and hinge pins (Figure 2, Item 2 and 8) that do not meet the
tolerances given in Table 1.
Table 1.
Roller and Hinge Pin Tolerances.
INSPECT FOR
DISPOSITION
ITEM
Roller
Outside diameter
Replace if less than 1.90 inches.
Inside diameter
Replace if greater than 0.64 inches.
Hinge pins
Outside diameter
Replace if less than 0.615 inch.
END OF WORK PACKAGE
0014 00-3/4 blank