d. Rig and install blade sleeve assemblies as follows: (Figure 2)
Blade sleeve assemblies are attached to each main rotor
blade. An adjustable length tie-down is attached between
the sleeve assemblys top D-rings and attached to the
shackle assembly during the recovery hook-up procedure.
A fixed length tie-down is attached to the bottom D-ring of
each blade sleeve assembly and secured to an appropriate
airframe point to secure the main rotor blades during the
(1) Orient blade sleeve assembly (Figure 2, View A) so that the markings saying TOP on both the blade
sleeve bag and straps are facing down.
(2) Fold both left and right edges of the blade sleeve bag inward until the matching loop/hook closures
(4) Open bag pocket number two on the blade sleeve bag (View A) by separating the loop/hook
(5) With one hand, take hold of blade sleeve bags left side blade sleeve tab and left side blue lifting tab.
(6) With other hand, take hold of blade sleeve bags right side blade sleeve tab and right side blue lifting
(7) Rotate the blade sleeve assembly so that the TOP markings are now fa cing up.
(8) Orient the blade sleeve open bag pocket so that it is fa cing away fr om the user holding the lifting
(9) Place the blade sleeve assembly lifting tabs fr om the bag and strap that are held in the left hand onto
Position 1 of the blade sleeve pole (View B).
(10) Place the blade sleeve assembly lifting tabs being held in the right hand onto Position 2 of the blade
(11) Place the remaining blue colored lifting tab on the lower edge of the blade sleeve assembly strap
onto Position 3 of the blade sleeve pole.
(12) Verify that appropriate blade sleeve assembly bag pocket is still open, and all other bag pockets are
(13) Pass the snap from one end of the adjustable length tie-down sling through the D-ring on the blade
sleeve assembly straps marked TOP and secure snap to loop position 2 on the adjustable length tie-
down. (View C)
(14) Connect the snap hook from the fixed length tie-down sling to the D-ring on the blade sleeve
assembly straps marked BOTTOM.
(15) The blade sleeve assembly is now ready for installation onto the rotor blade.
(3) Assemble blade sleeve pole. (View B)