TM 1-1270-476-30
6-27
6-6. NIGHT SENSOR HOLDING FIXTURE ASSEMBLY REPAIR (cont)
e. Allow silicone rubber adhesive to air dry for
30 to 60 minutes.
f. Position rubber pad (5) on clamping arm (1)
or support plate (6) and press firmly to
squeeze out excessive adhesive and
trapped air.
CAUTION
Do not apply solvent during trimmingand clean
up. Solvent may wick into adhesive joint and
damage bond.
g. Trim excess adhesive with clean, sharp
knife.
h. Tape pad (5) to clamping arm (1) or support
plate (6), until cured (para 2-6). Remove
tape.
i. Install clamping arm (1) using spacer
washer (4), bearing washer (3), and two
thumblocks (2).
END OF TASK
2. RECESS BUMPER REPLACEMENT
REMOVAL
a. Removed damaged recess bumper (1) by
removing screw (2).
INSTALLATION
b. Install new recess bumper (1) using screw
(2).
END OF TASK