4-5. NIGHT SENSOR ASSEMBLY (NSA) REPAIR (cont)
v. Remove old corrosion inhibitive sealing and
coating compound from all mounting
hardware removed in the removal
procedure (para 2-6).
w. Apply corrosion inhibitive sealing and
coating compound on all mounting
hardware just before installation (para 2-6).
Use class 1A application.
x. Install cooler/Dewar assembly (41) and
tighten three captive screws (40).
y. Install sleeve (39) on cooler/Dewar
z. Connect connector W10P2 (38).
aa. Using two rubber cushions between
harness and tiedown plates, secure W10
wiring harness to cooler/Dewar assembly
cavity with lacing and tying tape (37).